Pride Outlander Serie Manual De Usuario página 13

Onboard Battery Installation
The optional onboard battery is designed for easy
installation as it does not require any wires to be routed
through or under the vehicle.
To install the onboard battery:
1. Position the accessory bracket at desired location on
Outlander mast.
2. Secure with supplied hardware. See figure 8.
3. Align the mounting holes in the battery case bracket
with those in the accessory bracket. See figure 9.
4. Secure the battery case bracket to the accessory
bracket with the supplied hardware. See figure 9.
5. Insert the onboard battery into the battery case, making
sure that the connector on the bottom of the battery
aligns and fully connects with the mating connector
inside the battery case.
6. Plug the battery cord on the bottom of the battery case
into the mating connector running from the motor. See
figure 9.
Wiring Harness Installation
The wiring harness is approximately 25 ft. (7.62 meters)
long and will accommodate most vehicles.
NOTE: You may wish to perform a practice run before
installing the wiring harness. Route a piece of light
rope (equivalent to the gauge of the wiring harness)
along the anticipated path observing contact points,
potential rubbing/chafing points, and any sharp edges.
Remove sharp edges with a fine grade file, then treat
the steel with a rust inhibitor or metal sealant.
To route the lift system wiring harness:
1. Route the lift system wiring harness (starting at the lift)
through the interior of the vehicle until you reach the
vehicle battery. See figure 10. You will typically find
pass-through points at the rear lighting assemblies,
which will enable you to route the cable through the
trunk and under the back seat.
2. Conceal the harness behind or under the interior
panels of the vehicle (there should be existing holes).
Be certain that the harness is protected with a rubber
grommet when passing it through the metal panels
and into the engine compartment.
3. Inside the engine compartment, secure the harness to
the firewall and the inner fender with plastic wire ties.
Use care not to cause abrasions to the wiring harness.
It is important to secure the wiring harness at various
points along its run of the vehicle.
Outlander Series
I I I . I N S TA L L AT I O N
www.pridemobility.com
Figure 8. Accessory Bracket
BATTERY
CASE
BATTERY
CASE
BRACKET
Figure 9. Onboard Battery Installation
LIFT WIRING
CONNECTION
WIRING HARNESS
GROUNDING WIRE
HARNESS
VEHICLE BATTERY
Figure 10. Wiring Harness Installation
ACCESSORY
BRACKET
LIFT FRAME
13