Disposal And Recycling; Cleaning And Maintenance; Carbon Brushes - EINHELL EXPERT TE-SB 250 U Manual De Instrucciones

Anleitung_TE_SB_250_U_SPK8__ 26.09.12 15:58 Seite 28
GB
9.3. Freehanded cuts (Figure 43)
One of the most outstanding features of a bandsaw
is the ease with which it allows you to make curved
cuts and radii.
=
Lower the blade guide (11) down to the
workpiece. (See 7.6.)
=
Switch on the saw.
=
Hold the workpiece securely on the table (15)
and guide slowly through the blade (25).
=
Freehanded cuts should be made at low feed
speed so that you can guide the blade (25)
along the required line.
=
It often pays to first cut off surplus curves and
corners up to about 6 mm from the cutting line.
=
In the case of curves which are too tight for the
blade to cut correctly, it can help to make a
series of close-lying cuts at right angles to the
curved line. When you saw the radius the
material will simply drop off.
9.4. Sawing with the angle stop (Fig. 44)
With the saw table level you can use the angle stop
(19) to cut workpieces at a preset angle. With the
workpiece resting against the angle stop, push it into
the blade.

10. Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.
10.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.

10.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
28

11. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.