Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet DJ SCORPION Storm RGBY Manual De Usario

Operation

IRC-6 Infrared Remote Control

The Scorpion Storm RGBY can be operated with the CHAUVET IRC-6. To enable IR wireless control,
follow the instructions below.
1. Press <MENU> repeatedly until rEM shows on the display.
2. Press <ENTER>.

IRC-6 Operation

Automatic Mode
To turn on Automatic mode with the IRC-6:
BLACK
AUTO SOUND
OUT Sound-Active Mode
To turn on Sound-Active mode with the IRC-6:
SENSI-
STROBE SPEED
TIVITY
%
MANUAL
FADE
R G B
Strobe
To activate strobe with the IRC-6:
A UV W
-
+
0
1 2 3
4 5 6
Manual Control
To manually select the laser color with the IRC-6:
7 8 9
Speed
To adjust the motor speed with the IRC-6:
Line Segments
To adjust the length of line segments with the IRC-6:
Wireless Remote Control
To enter the remote control mode with the IRC-6 (does not work in Slave/DMX modes):
Black Out
To black out the lasers with the IRC-6:
This will turn off all the lasers until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
product does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out may have been activated.
• Any setting on the IRC-6 will be saved until the system is rebooted. The system will
revert to Auto Mode after reboot.
• The buttons on the IRC-6 not listed above are reserved for future use.
Scorpion Storm RGBY User Manual Rev. 1
1. Press <AUTO> on the IRC-6.
1. Press <SOUND> on the IRC-6.
2. Press the numbers <0–9> to increase or decrease the sensitivity
(9 is the most sound-sensitive).
1. Press <STROBE> on the IRC-6.
2. Press the desired color, from <R> (red), <G> (green), <B> (blue), or
<A> (yellow).
3. Press the numbers <0–9> to increase or decrease the strobe rate
(0 is blackout, 1 is the fastest, 8 is the slowest, and 9 is sound-activated strobe).
1. Press the desired color, from <R> (red), <G> (green), <B> (blue), or
<A> (yellow).
1. Press <SPEED> on the IRC-6.
2. Press the numbers <0–9> to increase or decrease the motor speed
(0 is stop, 1 is the fastest, and 9 is the slowest).
1. Press <%> on the IRC-6.
2. Press the numbers <0–9> to increase or decrease the length of the line
segments (0 is shortest; 9 is longest).
1. Press <SENSITIVITY> on the IRC-6 to enter remote control mode.
2. Press <SENSITIVITY> again to go back to the last mode.
1. Press <BLACK OUT> on the IRC-6.
Page 13 of 52