Rear Panel Features - Skytec SKY MKIII SERIE Manual De Instrucciones

8. Power Indication.
This clear blue indicator will light when the amplifier is turned on.

Rear Panel Features

1. 6.3mm Jack inputs.
Two 6.3mm jack female input connector
for connecting a signal source (mixer etc.).
2. RCA inputs.
Two RCA input connector for connecting a
signal source (mixer etc.).
3. Mode Switch.
The amplifier can use 2 different modes:
stereo & bridge. Choose one of
these functions: Stereo mode:
Standard left/right stereo mode.
Bridge mode: This mode combines both
amps on one channel which results in
double power on this channel. Connects
the signal to the left input channel and the
output level can now be adjusted with the
left volume control.
4. Ground Lift Switch. Allows circuit and
chassis grounds to be
separated in case of problems with earth
Installation
Connecting Output
loops (hum)..
5. 6.3mm Jack Outputs. Maximum load in
stereo mode 4 Ohm per channel.
6. Speaker Outputs NL4. Maximum load in
stereo mode 4 Ohm per channel.
Pin +1 & +2 = + output, Pin -1 & -2 = -
output
7. Binding Post Output Jacks. Maximum
load in stereo mode 4 Ohm per channel.
Maximum load in bridge mode 8 Ohm.
8. Mains Power Connector
9. Fuse
This main fuse secures the amplifier and
wires against defects. Replace this only
with a fuse of same type and value.
5 - 26