Skytec SKY MKIII SERIE Manual De Instrucciones página 6

Make sure the amplifier is turned off before you wire the system. Speakers can be connected using
speaker NL4 plugs or bare wire for your binding post output connectors. Using the guidelines below
select the appropriate size of wire bases on the disctance between the amplifier and speaker.
Distance Wire Size
<10m 1.5mm2
>10m <20m 2.5mm2
>20m <30m 4.0mm2
Setup operation mode
Amplfier can used in 2 modes:
1. Stereo operation
Set the mode selector (3) to the 'stereo' position.
In this mode the amplifier have two independed channels with there own inputs and volume controls.
2. Bridge operation
Set the mode selector (3) to the 'bridged' position.
This mode combines both amps on one channel which results in double power on this channel.
Connects the signal to the A input channel and the output level can now be adjusted with the A volume
control. Connect the speaker across the positive (+) output therminals. Do not use the negative (-)
terminals when the amplifier is being operated in bridged mode.
NOTE: Never connect a hot (+) output to ground or (-) output and never connect the hot (+) to
other hot outputs!
6 - 26