Protecting The Environment; Assembly And Adjustment - DeWalt DW710 Manual De Instrucciones

These are:
– Impairment of hearing.
– Risk of accidents caused by the uncovered parts of the rotating saw
blade.
– Risk of injury when changing the blade.
– Risk of squeezing fingers when opening the guards.
– Health hazards caused by breathing dust developed when sawing
wood, especially oak, beech and MDF.
Labels on tool
The following pictograms are shown on the tool:
Read the instruction manual before use
When using the machine in the mitre saw mode, make sure
that the upper part of the saw blade is fully covered by the
upper saw blade guard. Only use the machine when the bench
saw table is in highest position.
When using the machine in the bench saw mode, make sure
that the upper and lower guards are in place. Only use the
machine when the bench saw table is in horizontal position.
Carrying point.

Assembly and adjustment

Mounting the saw blade (fig. F1)
The teeth of a new blade are very sharp and can be
dangerous.
In order to fit a new saw blade it is necessary to adjust the table into
highest position and raise the saw head to its highest position.
• Retract the lower blade guard (8). To do so, push in the release knob
(32) and slide the guard back. Leave the guard retracted (fig. F1).
After mounting or replacing the blade, carry out a complete
movement of the saw head to check that the moveable lower
guard locks into rest position.
Ensure that all guards (mitre saw mode use and bench saw mode use) are
repositioned in position.
This information replaces the information of the instruction manual.
Instructions for use
Dust extraction
• When sawing wood, always connect a dust extraction device designed
in accordance with the relevant regulations regarding dust emission.
The following factors are of influence to dust exposure:
– worn saw blade
– dust extractor with air velocity less than 20 m/s
– workpiece not exactly guided
Transporting
• Transport the machine using the hand indentations.
Always transport the machine in saw bench mode with the
upper blade guard fitted. Never carry the machine by the guard.

Protecting the environment

Separate collection. This product must not be disposed of with
normal household waste.
Should you find one day that your D
or if it is of no further use to you, do not dispose of it with household
waste. Make this product available for separate collection.
Separate collection of used products and packaging allows
materials to be recycled and used again. Re-use of recycled
materials helps prevent environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection of electrical products
from the household, at municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and recycling of D
E
products once they have reached the end of their working life. To take
advantage of this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair agent by
contacting your local D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
details of our after-sales service and contacts are available on the Internet
at: www.2helpU.com
Machines in the scope of EN 61029 are not allowed for production use.
B&D_59
E N G L I S H
WALT product needs replacement,
E
WALT
E
WALT repair agents and full
E
9