Troubleshooting - Ryobi RY803100 Manual Del Operador

PROBLEM
Engine fails to start
Engine hard to start
Engine lacks power
Electric start feature not working Battery is not charged
Detergent fails to mix with spray High pressure nozzle attached
Pump doesn't produce pressure Low pressure nozzle installed
Machine doesn't reach high
pressure
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance section.
It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to perform the
required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible engine damage
and/or void your warranty.

TROUBLESHOOTING

POSSIBLE CAUSE
No fuel in tank
Spark plug shorted or fouled
Spark plug is broken (cracked porcelain or
electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug
Ignition inoperative
Choke in wrong position
Engine is flooded
Water in gasoline
Weak spark at spark plug
Dirty air filter
Battery wires disconnected
Soap tank is empty
Inadequate water supply
Trigger handle or spray wand leaks
Nozzle is clogged
Air in line
Hose is leaking
Kink in hose
Pump is faulty
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Wrong nozzle is attached
Page 18 — English
SOLUTION
Fill tank
Replace spark plug
Replace spark plug
Replace lead wire or attach to spark plug
Contact a qualfied service center
Move choke to START position to start a cold
engine. If engine is warm, choke should be in
RUN position.
Move choke to RUN position and pull the starter
grip and rope repeatedly until the engine starts.
Drain entire system and refill with fresh fuel
Contact a qualfied service center
Clean or replace air filter
Charge the battery using the battery maintainer
charger
Connect the battery wires.
Use blue soap nozzle to apply detergent
Add detergent to soap tank
Replace with high pressure nozzle
Provide adequate water flow
Check connections and / or replace trigger handle
or spray wand
Clean nozzle
Squeeze trigger on trigger handle to remove air
from line
Replace hose
Eliminate kinks in hose
Contact a qualfied service center
Replace with 3/4 in. garden hose
Check garden hose for kinks, leaks, and blockages
Open water source full force
Attach the high pressure nozzle