Corded Buttonhole - Kenmore 385.1 911 2 Manual De Instrucciones

Corded Buttonhole
Machine setting
_i} Stitch pattern: _ [[] _]
_2_ Stitch length:
_3}Thread tension: 1 - 5
_4_ Presser foot: Sliding buttonhole
f
@
J
\
[lJ With the buttonhole foot raised, hook the filler cord on
the spur at the back of the foot.
Bring the ends toward you under the foot, clearing the
front end.
Hook the filler cord into the forks on the front of the foot
to hold them tight.
_i} Spur
_2_Forks
I2/ Draw both of needle and bobbin thread to the left.
Move the slider toward you so that the top mark _4}on
the slider meets the start mark _3}.
_3_ Start mark
_4}Top mark
_5} Needle thread
_6} Bobbin thread
Lower the needle into the fabric at the starting point
and lower the foot.
Depress the foot control gently and sew the buttonhole
over the cord.
The sewing sequence is the same as the 4-step
buttonhole.
[13J Pull the left end of the filler cord to tighten it and cut the
excess tails.
To cut the buttonhole opening, refer to the instructions
on page 54.
%
/
/
/
®
%
®
56