Included Items; Technical Information; General Safety Advice; Your Working Area - Parkside PHKS 1450 LASER Instrucciones De Utilización Y De Seguridad

Laser oN / oFF switch
14
Cutting depth scale
15
Riving knife
16
Auxiliary handle
17
Drive spindle
18
Mounting flange
19
Clamping flange
20
Clamping screw with plain washer
21
Riving knife mounting
22
Mounting screws
23
Adapter for vacuum sawdust removal
24

Included items

Q
1 Circular saw
1 Guide fence
1 Adapter for vacuum sawdust removal
1 Allen key
2 Batteries, micro AAA 1.5 V (for laser)
1 operating instructions

technical information

Q
Nom. power input:
Rated voltage:
Mechanical output:
No­load speed:
Saw blade:
Cutting depth at 90°: 0 ­ 75 mm
Cutting depth at 45°: 0 ­ 49 mm
Protection class:
noise and vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A­weighted) of the device
is typically 93 dB (A). Uncertainty K=3 dB. The
sound level while working can exceed 104 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
Uncertainty K = 1,5 m / s
PHKS_1450_Content_LB5.indd 35
1450 W
230 V ~ 50 Hz
15 Nm max.
n 1800 ­ 5000 min
­1
0
210 x 30 x 1.8 x 2.6 mm
II /
= 2,309 m / s 2
h
2
Introduction / General safety advice
WARnInG!
The vibration level given in
these instructions has been measured in accord­
ance with a standardised measurement procedure
specified in EN 60745 and can be used to com­
pare devices. Different uses of the device give rise
to different vibration levels and in many cases they
may exceed the values given in these instructions. It
is easy to underestimate the vibration load if the elec­
trical power tool is used regularly in particular cir­
cumstances.
note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.

General safety advice

WARnInG! Read all the safety advice and
instructions! Failure to observe the safety advice
and instructions may result in electric shock, fire
and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUCTIoNS
IN A SAFE PLACE FoR FUTURE REFERENCE!

1. Your working area

a) Keep your working area clean and
clutter-free. Untidy or poorly lit working ar­
eas can lead to accidents.
Do not work with the device
b)
in potentially explosive en-
vironments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
Keep children and other
c)
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
GB/MT 35
30.07.2008 15:15:21 Uhr