Software Installation - Beta 1465 Manual De Uso E Instrucciones

EN I
OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO

SOFTWARE INSTALLATION

Before performing the test, make sure that the battery is charged; do not allow the engine to start during the test. (Depending
on the type of engine, the fuel pump fuse can be removed, and the injectors disabled by disconnecting the rpm sensor etc.).
Operating the tool requires Bluetooth connection with a computer where the software must be installed.
Take the following steps:
1. Install the software in the USB key.
2. Supply power to the tool, connecting the power supply cables to the battery of the vehicle.
3. From the Bluetooth menu, search for new devices, and pair the tool, choosing a number of COM port lower than 15.
4. Run the software, and press "FORWARD". The software will search for the device; when the device is found, the green light
on the software window next to the Bluetooth will turn on.
5. Enter the "SERIAL NUMBER" and "PASSWORD", which are usually found in the packaging.
USE
After taking the necessary precautions, to prevent the engine from running, connect the tool to the motor vehicle battery using
the alligator clamps as follows:
• RED CLAMP to the positive terminal, BLACK CLAMP to the negative terminal;
• Connect the tool to the PC (by Bluetooth) and start the software that must receive and analyse the test data.
12