Operation; Clock Set - Haier AS20S2SD1FA Manual De Operación

Operation

23
22
21
20
19
18
Note:
1. SMART+SLEEP: W hen the light sensing function is enabled,
the appliance will be in the
detects that indoor light is weak (lower than the setting
value) for several minutes, the light sensing function
works automatically. If theappliance detects no movements
of people for 20 minutes , during which the light is weaker
than the setting value , it will enter the "SMART+SLEEP"
mode automatically. The appliance will operate as per the
sleep curve.(See the"SLEEP"function in Page 7).
Conditions to exit:
1) The appliance detects that the indoor light is stronger
than the setting value for 20 minutes.
2) The appliance is in the 8h "SMART + SLEEP" mode.
3) The "LIGHT SENSING" function is disabled.
When any of the above conditions is met, the appliance will
exit from the "SMART+SLEEP" mode. Once out of the
"SMART+SLEEP" mode, the appliance will operate under
the operation status initially set on the remote controller.
Note:1) This function is not available in the "AIR SUPPLY"
mode.
2) This function is not available in the "SLEEP"mode.
3) When it is in the "REMOTE SLEEP" mode or the
"TIMER"is on, the appliance will exit from this function.
4) Light sources like indoor lamps and TV's LED
light,and frequent movement s of pets will affect this
function.
2. Press "HEALTH"+"HEALTH AIRFLOW" simultaneously can
set and cancel the "LOCK" function (
18. TIMER button
19. CLOCK button
20. 10 ºC button
special heating set
function: 10 degree
heating maintaining
(valuable for RS)
21. HEALTH button
22. SMART button
Used to set SMART
operation. (This function
is unavailable on some
models.)
23. SWING up/down button
24. SWING left/right button
25. SLEEP button
26. HEALTH AIRFLOW button
24
27. LIGHT button
Control the lightening and
25
extinguishing of the indoor
26
LED display board.
27
28. CODE button
A-b yard
28
29
29. APPLY button
30
30. °F/°C button
mode. If the appliance
)

Clock set

Note:
The distance between the signal transmission head and
the receiver hole should be within 7m without any obstacle
change-over wireless telephone is installed in the type
in receiving the signals, so the distance to the indoor unit
should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can't run normally during operation,
please remove the batteries and reload several minutes later
Hint:
Remove the batteries in case unit won't be in usage for
a long period.
1
Press CLOCK button,
2
Press "+" or "-" to set
correct time.
Each press will increase or
decrease 1min. If the button is
kept pressed, time will change
quickly.
3
press APPLY, "AM" and
starts working.
.
2