Kenmore 911.47822 Instrucciones De Uso Y Cuidados página 9

OPERATION
Oven Control, Clock and Timer
Your new control has a series of tones
that will sound at different times.
These tones may sound while you set
the control for an oven function, or at
the end of the oven function. It will also
alert you that there may be a problem
with the functions. Below are the types
of tones and a brief description of
each.
TONES WHILE SE'I-rlNG THE
CONTROL-- When you press a touch
pad you will hear a beep. This beep
will let you know you have placed
enough pressure on the pad to activate
it. (The arrow pads do not beep.)
END OF TIMED CYCLE TONE -- At
the end of a timed cooking function,
you will hear 3 short beeps followed
by 1 beep every 6 seconds. This 6
second beep will continue to sound
until the CLEAR/OFF pad is pressed
or you may select the special feature
to cancel this 6 second beep from
sounding at the end of future cycles.
TO CANCEL THE 6 SECOND BEEP
1. Press and hold the BAKE and
BROIL pads, at the same time for
3 seconds, until the display shows
"SF."
2. Press the KITCHEN TIMER pad.
The display will show "CON
BEEP" (continuous beep).
3. Press the KITCHEN TIMER pad
again. The display will show
"BEEP" (beep canceled).
4. Press the START pad to cancel
the 6 second beep and leave the
special feature mode.
if you would like to return the 6 second
beep, repeat steps above until the
display shows your choice and press
the START pad.
ATTENTION TONE -- This tone will
sound if you make an error or an
oversight is made while setting an
oven function.
Examples would be:
a. Setting a clean cycle and the oven
door is not properly closed.
b. Setting function and not pressing
the START pad.
¢. Pressing an additional function pad
without first setting a temperature
or time.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE -- When you
set an oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking.
If the control beeps while the display
is showing "F" and a number or letter
such as "F-4" or "Fr' there may be a
problem with the control or oven.
Simply press the CLEAR/OFF pad
and wait about an hour. Try setting the
function again. If the code repeats,
write down the flashing code and call
for service. Tell the technician what
code was flashing.
9