Existing Construction (Below Ceiling Access Application) Installation Instructions - Utilitech 00761 Manual De Instrucciones

EXISTING CONSTRUCTION (JOIST/ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
14. Strip 1/2 in. of insulation from wire ends. Grip the wire
firmly and push the stripped end of the wire into the
open port of two-port quick connect (GG) or three-port
quick connect (HH). Use only one stripped end of the
wire per port. Verify the stripped end of the wire is fully
inserted to the back of two-port quick connect (GG) or
three-port quick connect (HH).
Hardware Used
G
Two-port Quick Connect
~
x3
~
Three-port Quick
Connect~
x 1
15. Install the previously removed wire housing cover (J)
into the housing (A) and secure using the wire housing
screw (FF). Ensure all of the wiring connections are
inside of the housing (A) or under the wire housing
cover (J).
Hardware Used
48
Wire Housing Screw
~
X
1
Proceed to FINAL INSTALLATION INSTRUCTIONS on
page 18.
house
wires
0
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
1. Perform one of the following steps based on the
installation type:
a. If there is an existing fan in place, remove the existing
fan and ensure that the opening in the ceiling is large
enough for the new fan. Use the template (G)
provided to determine if the existing hole in the ceiling
is large enough for this new fan to be installed. You
may be required to make the hole larger to match the
size of the template (G) provided.
Note: If the existing hole from the previous fan is
larger than the template (G), the hole must be
made smaller to match the template (G)
provided.
b. lfthere is not an existing fan in place, choose the
location in the ceiling and cut an opening according
to the size of the template (G). Ensure that one edge
of the opening aligns with the edge of the joist.
15
joist
............
·~
__________
..._
...
~
UTILITECH' ]
Lowes .com ~
- · - :