Conformity And Approval; Inserting Batteries; Switching On /Off Muting - Monacor JTS MH-36G2/5 Manual De Instrucciones

2 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only Protect
it against dripping water and splash water, high
air humidity and very high or low tempera-
tures (admissible ambient temperature range:
0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly operated, or if it is not repaired
in an expert way
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment
3 Applications
Combined with the JTS receiver US-36G2 /5,
this dynamic hand-held microphone with UHF
transmitter creates a wireless audio transmission
system (506 – 542 MHz) Just like on the receiver,
the transmission frequency can either be selected
from one of the 6 preset groups or directly set in
steps of 25 kHz

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the wireless microphone MH-36G2 /5 com-
plies with the directive 2014/53/EU The EU dec-
laration of conformity is available on the Internet:
www jts-germany de or www monacor com
The wireless microphone may be operated in the
following countries:
DE
In the Federal Republic of Germany, the wireless
microphone requires a frequency assignment
(for which a fee is charged) In other countries,
it is necessary to apply for a corresponding ap-
proval Prior to operating the wireless transmis-
sion system outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
national authorities can be found via the following
Internet address:
www cept org
 ECC
 Topics/Info
 SRD* Regulations and indicative list of equip-
ment sub-classes
 EFIS and National Frequency Tables
* Short Range Devices

4 Inserting Batteries

For power supply, two 1 5 V batteries of size AA
are required
•
Only insert batteries of the same type and al-
ways replace both of them
•
If the microphone is not in use for a longer
period of time, always remove the batteries as
a precaution to prevent damage due to battery
leakage
1) Unscrew the microphone cartridge (1) (fig 3)
2) To unlock the battery holder (8), push the
latch (7) in the direction of the arrow (fig 4)
3) Pull out the battery holder to the stop (fig 5)
and insert the batteries with the positive and
negative poles as indicated on the holder
4) Push back the battery holder until it locks
5) Place the microphone cartridge on the handle
so that the connectors (6) of cartridge and
handle fit together, and then screw the car-
tridge onto the handle
Never put batteries in the household
waste; always take them to a special
waste disposal, e g collection container
at your retailer
5 Switching on /off
Muting
To switch on, press the button
For detailed information on the display indications
refer to chapter 1:
☞
To mute the sound, press the button
briefly; the display will briefly indicate
When the sound is muted, the display backlight
starts flashing To unmute the sound, press the
(4) briefly
display (2)
9