Renz DTP 340 A Instrucciones De Servicio página 20

Technical Data DTP 340 A
Machine number:
Year of Manufacture:
Voltage:
Power requirement:
Type of protection:
Glass tube fuse 5 x 20
Punching and Perforating Possibilities
All common types of punching operation and perforation
Working width
Space Requirement
Length
Width
Height
Weight
56.5 kg ( 124 lbs. )
Before installing the DTP 340 A please carefully read these operating instructions. Ensure that all ma-
chine operators are familiar with the machine and in particular with the safety regulations.
Safety Instructions
All relevant safety regulations of the employer´s liability insurance carrier and supervisory authorities are applica-
ble.
Intended Use
The DTP 340 A is intended to be used as a punching and perforating machine. It is not allowed to use the machine
for any other purposes.
All operators must be familiar with the safety regulations and the intended use of the machine.
Caution:
Cover plates on the machine must not be removed under any circumstances!
Repairs must only be performed by the manufacturer!
Machine installation
The machine must not be installed in potentially explosive atmospheres or in damp locations.
The relative humidity must not be more than 80% and the temperature must not be higher than 35 ºC. ( 95° F )
Lift the machine out of the box by holding the base with both hands and position the machine on a stable surface.
Do not lift the machine using the two handles.
Caution: Be careful not to damage any cables!
230 V 50 Cc on request 115 V 60 Cc
450 watt
IP 30
230 V / 4 A T
340 mm ( 13,5" )
68 cm ( 27" )
93 cm ( 37" )
33 cm ( 13" )
115 V / 8 A T
4