Disposal Of Waste Material; Application; Troubleshooting - Renz DTP 340 A Instrucciones De Servicio

9. Disposal of Waste Material

1. Application

1. Do not punch materials that are too thick. Metals or thick plastics must not be punched at all.
2. Do not use the machine for any other purpose other than punching as it may be damaged.
3. Both fan grilles must always be free of obstructions to cool the motor.
4. Do not reach into the paper feed. Risk of injury.

2. Troubleshooting

If there are difficulties, please check the following points, before you call customer service.
The unit is not working.
Is the main switch on?
Is the electric plug plugged in correctly?
Is the foot switch plugged in correctly?
Is there a fault in the power supply?
Is the fuse faulty?
The fuse is located in the left-hand side of the unit, below the main switch.
1 replacement fuse is included.
In the OFF position the punching operation can only be triggered with the foot
pedal.
In the ON position the punching operation is triggered automatically and
should not be triggered with the foot pedal.
Please do not carry out any repairs under any circumstances, as this may be dangerous. In
the case of a fault, please return the unit to the factory with details about the fault.
Guarantee: We offer a guarantee of 1 year on this unit, when handled with care.
Dated 06 / 2000
Regularly empty the waste drawer at the
rear of the machine.
11