Publicidad
Quick operation guide
However, it is possible to continue navi-
gating through the main menu by pres-
sing the UP
or DOWN
The status screen shows the alarms or
notifications about the current condition
of the lifter.
SYS OK P: 001
HIT ENTER TO DMX
But when the Showlift is ready to be used
the status screen will show the following
information:
This screen shows the current height of
the lifter and the option to press "Enter" to
change the mode to DMX automatically
to start working. In case the user wants to
work in MANUAL mode, simply press the
UP
or DOWN
through the menu.
It is recommended to make position re-
sets each time the lifter is powered up. In
case of a power cut or in case the Showlift
YOU MUST RESET
POS REFERENCE
is powered up with a height value of
DMX=2 or less the display will show the
following information:
IN THE EVENT OF A
SUDDEN POWER FAILURE:
If at the time of the power cut the Showlift
was in motion, the few seconds of move-
ment without power before it stops cau-
ses the lifter to lose its height reference,
so when it is turned on again the lifter will
display a reset message.
But it is possible to lower the lifter in or-
der to recover the top fixture by selecting
the "MANUAL UP/DN" option with the
UP
/ DOWN
buttons, then pressing
PRO LIFTS S.L.
buttons.
buttons to navigate
Depósito legal y copyright 2018. Todos los derechos reservados.
ENGLISH
the RIGHT
button to modify the height,
and press the DOWN
4 MANUAL UP / DN
< ??? >
However the height will not be displayed,
instead three question marks will appear.
RESET:
There are two different RESET options,
one is the position reference displayed as
"Pos reference", in which the tower will
do a new search for its position 0, des-
cending until touching the base, then it
will come back to the previous height.
The second reset option is the factory de-
fault settings restore, displayed as "Fac-
tory def", in which the tower erases its
current position reference (so then a po-
sition reference reset must be done), res-
tores the maximum and minimum height
and speed restrictions, and also the dead
man switch option turns inactive. Finally
the lifter establishes the height value in
DMX=1.
To choose between these two reset op-
tions, press the RIGHT
, then the option will appear between
brackets (<>). Then press the UP
DOWN
buttons to select one of them.
10 RESET
< POS REFERENCE >
Finally press the central button "Enter" in
order to choose the desired option.
DMX & MANUAL MODE:
To select between MANUAL or DMX
mode, press the RIGHT
button to lower.
button to edit
or
10 RESET
< FACTORY DEF >
button to edit
10
Publicidad
