Electrical Connection; Three-Phases Machine; Single-Phase Machine; Start And Stop - Berkel BM +42F Serie Manual De Uso Y Manutención

4.4 - Electrical connection

WARNINGS!
Check that the electrical power supply corresponds to the value indicated on the
rating plate of the machine.
All these interventions must be performed exclusively by skilled technicians author-
ized by the responsible.
Connect the machine to a line equipped with an efficient ground installation.
4.4.1 - Three-phases machine 380 Volt-50Hz and three-phases
machine 220 Volt-50 Hz
The mincer is equipped with a power supply cord
with section 4 x 1,5 mm.
It is connected to a three-phase + earth plug.
Connect the cord to the three-phases power supply by interposing
a differential-magnetothermic switch of 16 Ampere.
4.4.2 - Single-phase machine 220 Volt-50 Hz
The mincer is equipped with a power supply
cord with section 3 x 1,5 mm.
It is connected to a three poles single-phase
plug.
Connect the cord to the
single-phase power supply by interposing a differential-
magnetothermic switch of 16 Ampere.
For the installations with other voltages, consult the manufactuer.
If you need to lengthen the power supply cord, use a cord of the
same section as the one provided by the manufacturer.

5 - Start and stop

5.1 - Check the electrical connection

Connect the plug to the power supply;
Press the on push-button ("1" Fig. 3.1.1), and check the rotation sense of the tools
(for the three-phase model 380).
The rotation sense of the propeller screw must be anticlockwise.
If the rotation sense is not correct, disconnect the machine from the power supply
and call the after-sale service.
Note:
For the machines connected to a single-phase line, the rotation sense is set by the
manufacturer.
N: usually it is of blue colour or by N° 4 indicated
15