Hybrid Cleaning - Samsung NY36R9966P Serie Manual Del Usuario

To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, turn both the mode and temperature
selector knobs to the OFF position. The cycle turns off, but the door remains locked
until the oven temperature falls below 400 °F (205 °C).
After self-cleaning
• The door stays locked until the internal oven temperature falls below 400 °F.
• When the oven has cooled down, wipe the oven surfaces with a cloth to
remove ash residue.
• Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
• If you are not satisfied with the cleaning results, repeat the self-cleaning cycle.
• The oven will not let you repeat a self cleaning cycle immediately You must
wait 2 hours before running self-cleaning again.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.
NY9900R_CHEF_NY36R9966PS_AA_DG68-01105B-00_EN+MES+CFR.indb 35

Hybrid cleaning

The Hybrid cleaning function saves time and energy by removing leftover grease
and residue that you can wipe away with a damp cloth.
Before a hybrid cleaning cycle
•
•
•
Fig. 1
•
Don't hand
clean the
oven door
gasket.
You may
hand clean
•
the door.
Fig. 2
•
NOTE
Remove oven racks and accessories before starting the Hybrid Clean mode.
Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.
Wipe up debris from the oven bottom.
(Fig. 1)
The silver-colored oven racks can be
Hybrid cleaned, but they will darken,
lose their luster, and become harder to
slide.
Residue on the front frame of the oven
and outside the gasket on the door
will need to be cleaned by hand. Clean
these areas with hot water, soap-filled
steel-wool pads, or cleansers such as
Soft Scrub. Rinse well with clean water
and dry.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you
notice it becoming worn or frayed, have
it replaced. (Fig. 2)
Make sure the oven light cover is in
place and the oven light is off.
English 35
2019-02-06 1:26:32