Maintenance
Cleaning
Control panel
First, lock the control panel and the door to prevent accidental operations and/or
product tipping.
Press and hold the START/SET pad for 3 seconds to lock both the control panel
1.
and the door.
2.
Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3.
When done, press and hold the START/SET pad again for 3 seconds.
WARNING
•
Make sure the control panel turns off and all surfaces of the range are cool
before cleaning. Otherwise, you can get burned.
•
If the range has been moved away from the wall, make sure the anti-tip
device is reinstalled properly when the range has been put into place again.
Otherwise, the range may tip over, causing physical injuries.
•
Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1.
Remove any spills, spots, and grease stains using a soft, wet cloth.
2.
Apply an approved stainless steel cleanser to a cloth or paper towel.
3.
Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
When done, dry the surface using a soft, dry cloth.
4.
5.
Repeat steps 2 through 4 as many times as necessary.
CAUTION
•
Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces.
They will scratch the surface.
•
Do not spray any type of cleanser into the manifold holes. The ignition system
is located in those holes and must be kept free of moisture.
NX5000M_NX58M6650WS_AA_DG68-00993A-00_EN+MES+CFR.indb 37
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm,
soapy water. Then, scour impurities off of the racks using a plastic scouring pad.
If the racks do not slide in and out smoothly after you have cleaned them, rub the
side rail guides with wax paper or a cloth containing a few drops of cooking oil.
This will help the racks glide more easily on their tracks.
NOTES
•
Do not put the racks in a dishwasher.
•
If a rack does not slide in and out smoothly, apply a few drops of cooking oil
to the oven rack guides.
•
If a rack becomes too difficult to slide in or out, lubricate the rack with
graphite lubricant.
•
To purchase the graphite lubricant, contact us at 1-800-SAMSUNG (726-7864).
•
For online shopping, visit http://www.samsungparts.com/Default.aspx and
search for part DG81-01629A.
CAUTION
•
Do not leave the racks in the oven during the self-cleaning cycle. The extreme
heat generated in this cycle can permanently peel off the rack coating and
make it difficult to slide the racks on the guide rails.
•
Do not spray cooking oil or lubricant directly onto the racks.
Door
Do not remove the inner gasket of the oven door for cleaning.
Inner side
•
Inner surface: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket
wet or allow moisture into the door.
•
Inner glass: The inner glass is cleaned automatically during the self-cleaning
cycle.
English 37
6/29/2017 1:09:30 PM