Connecting The (Optional) Clip Microphone Or Headset - Kenwood WD-K10PBS Guia Del Usuario

The battery charge LED lights up in red and charging begins.
The transceiver turns off automatically if it is placed on the charger
●
while it is turned on. For safety purpose, turn off the transceiver
during charging.
Check that the metal terminals of the transceiver are in firm contact
●
with the terminals on the charger.
The battery charge LED goes off when charging is complete. Take
out the transceiver.
The estimated time required to complete the charging is as
●
follows:
WD-K10PBS: approx. 6 hours
WD-K10TR: approx. 5 hours
CAUTION
Be sure to use the specified charger KSC-48CR to charge this unit.
●
CONNECTING THE (OPTIONAL) CLIP MICROPHONE OR
HEADSET
Connect to the optional clip microphone or headset.
Compatible model: EMC-13/ EMC-14/ KHS-37
●
Note:
Be sure to read the instruction manual of the connecting device
●
before using.
Make sure to turn off the transceiver before making a connection.
●
Making a connection while the transceiver is turned on activates the
protector which disables operation on the transceiver. The clip
microphone or headset is also disabled.
14
Insert the connecting plug
into the connecting jack of
the transceiver, and
secure by turning the cap
in the direction of the
arrow.