Making A Call In Group Call Mode; Making An All Call - Kenwood WD-K10PBS Guia Del Usuario

MAKING A CALL IN GROUP CALL MODE

The unit enters into Group Call mode immediately after turning on
the power. Press the [PTT] key directly to call everybody in the
same group.
Note:
To configure or change the group, use the Programming Software
●
WD-ZS10, or consult the authorized dealer or installer.
Changing the group to make call
o
Press the [Group Select] key configured in the function key to
change the current group to another group.
When the group is changed, the corresponding Group LED blinks
and the group name is announced.
Note:
When this unit is turned off after changing the group, the group to
●
connect to when the unit is turned on again vary according to the
setting of the unit.
If "Resume" is configured for "Power On Group": The group that the
–
unit belonged to before turning off the power is connected.
If a group is specified for "Power On Group": The specified group
–
is connected regardless of the group that the unit belonged to
before turning off the power.

MAKING AN ALL CALL

You can make a call to everyone in all the groups that the
transceiver in use belongs to.
1 Press and hold the [All Call] key.
A "pee-poo-pee-poo" sound and an All Call tone can be heard from
the earphone.
When a call invalid tone is heard, wait for a while and retry again.
●
2 Speak into the microphone while pressing the [PTT] key.
3 After the All Call has ended, press the [All Call] key again.
A complete tone is sounded and the unit returns to Group Call mode.
23