Accessories - Festool CARVEX PS 420 EBQ Manual De Instrucciones

GB C A R V E X
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
– Check the guidance roller regularly for wear.
– Regularly remove dust deposits from the
chip guard.
– Regularly clean the base runner to prevent
scratches and cores on the surface.
10

Accessories

The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli-
cations that are specially designed for your
Festool jigsaw.
10.2 Sawing with special base runners
The special base runners protect high-quality
surfaces against scratches and scores.
Press in the base runner at position [6-1].
At the same time, push the base runner
forwards.
Mount another base runner and push it to
the rear until it engages.
10.3 Sawing with the angle table
The angle table WT-PS 400 is used for cutting
pipes or interior and exterior angles up to 45°.
Dust extraction is not possible when
sawing with the angle table!
Installing the angle table
Remove the saw base [1-11], (see chap-
ter 7.4).
Position the angle table against the saw
base support.
Close the lever [1-9].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
Turn the adjusting wheel [7-1] to select
the required angle.
You can select the angles -45°, 0° and +45°
on the scale [7-2].
18
WARNING
Sawing cutting depths
Risk of injury
Select the saw blade length and cutting
depth so that the saw blade remains
plunged in the workpiece.
For 90° cuts, we recommend setting the
angle table to a small negative angle to
guarantee smooth operation.
10.4 Sawing with the adaptation table
The adaptation table ADT-PS 400 is used for
attaching your jigsaw to the Festool guide rail,
the circle cutter KS-PS 400 and the CMS mod-
ular system.
With guide rail and circle cutter: do
not exceed max. material thickness of
20 mm and always use cross-set saw
blades (FSG).
Installing the adaptation table
Remove the saw table [1-11], (see chap-
ter 7.4).
Mount the adaptation table [8-1] on the
saw table support.
Close the change lever [1-9].
Ensure that the adaptation table is firmly seat-
ed in the guide.
Use the extractor connector [1-8] also
with the adaptation table.
Adaptation to the guide rail FS 2
The Festool guide system FS 2 (Fig. [9])
makes it much easier to manufacture straight
precision cuts.
Place the jigsaw with attached adaptation
table [8-1] on the guide rail.
Adaptation to the circle cutter
The circle cutter can be used to create circular
cuts with a diameter between 120 and 3000
mm. The circle cutter can be installed from
both sides on the adaptation table.
Place the jigsaw with attached adaptation
table on the adapter [10-1] on the circle
cutter.
Insert the centring mandrel [10-2] in the
hole [10-4] on the circle cutter aligned
with the saw blade.
Clamp the measuring tape to the circle cut-
ter using the rotary knob [10-5].
Recommended when using the circle cutter: