Sears Kenmore 790.79992 Manual Del Usuario página 10

Surface Cooking
The controls shown below may not
look identical to the Surface Controls
knobs on your range; They are only
representational,
Hi
/
Sett[,;_
Surface
Co_ltrots
Your range may be equipped with any combination of the following burners:
Simmer Burner, this burner is best used for simmering delicate sauces, etc
Standard Burner, can be used for most all surface cooking needs
Large Burner, the larger burner is best used when bringing large quantities of
liquid to temperature and when preparing larger quantities of food..
Regardless of size, always select a utensil that is suitable for the amount and
type of food being prepared,. Select a burner and flame size appropriate to the
pan Never allow flames to extend beyond the outer edge of the pan
Each burner lights automatically from an electric ignitor each time a control
knob is turned to the LITE position
_t_3_[_ Do not place plastic items such as salt and pepper
shakers, spoon holders or plastic wrappings on top of the range when it
is in use, These items could melt or ignite, Potholders, towels or wood
spoons could catch fire if placed too close to a flame,.
1 Place cooking utensilon burner
2. Push the Surface Control knob tn and turn counterclockwise out of the
OFF position.
3 Release the knob and rotate to the LITE position Note: All four electronic
ignitors will click at the same time However', only the burner you are
turning on will ignite.
3. Visually check that the burner has lit.
4 Push the control knob in and turn counterclockwise to the desired
flame size The control knobs do not have to be set at a particular mark
Use the guides and adjust the flame as needed, DO NOT cook with the
Surface Control knob in the LtTE position.. (The electronic ignitor will
continue to click if left in the LITE position.)
In the event of an electrical power outage, the surface burners can be lit
manually. To light a surface burner, hold a lit match to the burner head, then
slowly turn the Surface Control knob to LITE. After burner lights push in and
turn knob to desired setting. Use caution when lighting surface burners
manually
10