Installing Adas Positioning Using Ddm; Installing The Bosch Adas Positioning Software; Adapting The Camera By Qr Code; Operation - Bosch SCT 17 Instrucciones De Servicio

1
2
(1) Lower mount for reference board
(2) Star knob
(2)
5. Use the screw and washer
tangular bar with the screw plate
plate.
1
2
3
(1) Screw plate
(2) Screw
(3) Washer
---Separator---
3.4 Installing ADAS Positioning using
DDM
Bosch ADAS Positioning is available through Diag‐
nostics Download Manager (DDM).
The customer number and password are included
on the delivery slip of the Bosch diagnostic pro‐
gram.
1. Should DDM not be installed yet, download DDM
from the following link: https://www.down‐
loads.bosch-automotive.com/de/ddm/esi20-eu/
2. Use the customer number and password to log into
DDM.
3. Perform the one-time configuration of DDM.
4. Select Bosch ADAS Positioning for installation.
 Bosch ADAS Positioning will be installed on the
laptop/tablet.
 Updates of Bosch ADAS Positioning will be auto‐
matically installed by DDM.
---Separator---
Robert Bosch GmbH
3.5
1. Connect the USB stick to the laptop/tablet.
2. Open "Bosch ADAS Positioning Setup.exe".
3. Select the language for the installation wizard.
4. Follow the installation steps.
---Separator---
3.6
(3)
to secure the rec‐
Prerequisite:
(1)
on the base
Bosch ADAS Positioning must be installed on the lap‐
top/tablet.
---Separator---
1. Start Bosch ADAS Positioning.
2. Connect the camera to the laptop/tablet.
3. Place the included QR code inside the green box in
---Separator---
4.
4.1 ---Separator---
Prerequisites:
• The camera must be attached to the camera bracket
• Bosch ADAS Positioning must be installed on the lap‐
• The camera must be adapted.
---Separator---
1. Start Bosch ADAS Positioning.
2. Connect the camera to the laptop/tablet.
3. Select a reference point for distance measurement
.
4. Follow the instructions in Bosch ADAS Positioning
5. Position the adjustment device in front of the vehicle
Installing the Bosch ADAS Positioning
software
As of October 2019, the Bosch ADAS Positioning
software and software updates will be made
available through Diagnostics Download Manager
(DDM).
— Should the USB stick not be started automatically,
open the USB stick directory.
 The installation wizard will start.
 Once the installation is complete,
Bosch ADAS Positioning can be used.

Adapting the camera by QR code

 The camera will be initialized.
 The camera image will be displayed.
the camera image.
 The camera will be adapted.
 The camera is now ready for operation.
 The serial number of the camera will be saved to
the settings.

Operation

Aligning the adjustment device by us‐
ing SCT 17
on the adjustment device.
top/tablet.
between the adjustment device and the vehicle.
— Select the bumper as a reference point.
— Select the wheel hub as a reference point.
— Select a manufacturer-specific reference point.
for positioning the reference board.
— Position the reference board in such a way that it
is fully within the camera image at all times.
according to the vehicle-specific specifications.
— Refer to the corresponding brief instructions for
vehicle-specific specifications.
SCT 17 | 13 | en
1 689 989 391 | 2018-08-01