Human Touch Perfect Chair Laptop Desk Manual De Uso Y Cuidado página 4

4. Place one of the washers you removed earlier onto each of the two longer screws (provided), insert the screws into
the two center bracket holes, then hand-tighten (Fig.4).
5. If you cannot fully insert the screws into the holes, do the following:
a. Using a flat-head screwdriver, turn the barrel nut located on the back of the armrest so that the slot is
horizontal (Fig.5).
b. Standing above the armrest, visually inspect the screw holes to determine whether the screw holes are aligned with
the holes in the barrel nut; if they are not, use a Phillips-head screwdriver or a pen to align the bolt holes with the
screw holes.
c. Repeat step 4.
6. Insert a short screw into one corner bracket hole and another short screw into the hole diagonally opposite the first
hole, to ensure all holes are well aligned.
7. Use the larger Allen wrench to firmly tighten the two center screws, then remove the two short screws from the corners
of the bracket.
(Fig.4)
(Fig.5)
humantouch.com
Allen screw
Washer
Slot is horizontal
Barrel nut
4
Install the armrest cap
1. Place one of the washers removed earlier onto each of the four short screws (provided).
2. Place the armrest cap into position (Fig.6).
3. Replace and partially tighten the two rear armrest screws.
4. If you have an accessory table, place it into position.
5. Replace and hand-tighten the two front armrest screws.
6. Use the larger Allen wrench to moderately tighten the four screws (Fig.6).
Larger Allen wrench
(Fig.6)
Armrest cap
5