Human Touch Perfect Chair Laptop Desk Manual De Uso Y Cuidado página 7

Install the edge stops
Your Laptop Desk comes with two tall edge stops, for use with laptops, and two short edge stops, for use with iPads and
netbooks. These stops, combined with the holes along the inside edge of the desk, enable you to hold virtually any device
securely on the desk when the desk is tilted.
1. With the object you intend to use in place on the desk, determine whether the taller or shorter stops are best suited to
hold the object. Do not use more than two stops at one time.
2. Choose the desired location in which to install the first stop.
3. While squeezing the stop sides firmly toward each other, insert the ends into the corresponding desk holes and push the
stop inward halfway before releasing the stop sides (Fig.15).
NOTE: Repeated installation of the edge stops without squeezing the sides together will eventually enlarge the holes and
they will no longer hold the stops in place.
4. Push the stop the rest of the way into the holes, as far as you can.
5. Repeat steps 2 – 4 to install the other stop.
6. Once all desired stops are installed, slide the rubber bumpers up or down to the location that best protects the edges
of your device from becoming scratched.
7. Store the unused edge stops in a convenient place, so you can locate them when using a different device.
(Fig.15)
IMPORTANT: When removing the edge stops, be sure to squeeze the sides firmly toward each other before pulling the
stops out of the holes.
humantouch.com
Squeeze the stop sides Edge stop installed
10
Adjust the desk tilt
Grasp the Laptop Desk with your hands on both sides, then tilt it forward, for optimal viewing angle.
Install the cable clips
If you are using an outlet-powered device, you can use the provided
cable clips to secure the device cables to the Laptop Desk arm,
conveniently out of the way.
1. Attach the first clip to the desk arm, underneath the desk.
2. Attach the second clip to the arm, near the bend.
3. Snap the cable into the cable guides on each clip.
Adjusting the desk arm tension
You can increase or decrease the desk arm tension, to make it easier
or more difficult to swivel the desk arm forward and backward.
1. While sitting in the chair, locate the tension screw on the desk post.
2. Turn the screw clockwise to increase the arm tension or
counterclockwise to decrease the tension.
Cable clip
Device cable
Tension screw
11