Traditional Chemical Start Up; Bromine Clear Water Plan - Cal Spas Aqua SQ63 Manual Del Usaurio

Traditional Chemical Start Up

Prior to filling a spa for the first time, or after a routine
draining, you will want to follow this start-up plan to
extend water life and performance. If you are following
either the Bromine or Chlorine "Clear Water Plans",
you will notice that both start-up processes are the
same with the exception of Step 6. As with all chemical
dosages listed in these "Clear Water Plans", start-up
dosages are intended for 500-gallon spas. Please
adjust the chemical dosages to the capacity of your
particular spa.
Start Up
1. Clean surface of spa with Cal Spas "Multi-Purpose
Cleaner".
2. Apply a protective coat of Cal Spas "Fast Sheen" to
the acrylic surface.
3. Fill spa to proper water level with normal tap water
(Do not use soft water)
4. Use test strip and balance the spa water:
• Adjust total alkalinity (acceptable range is 80-
120ppm),
• Then adjust pH if necessary (between 7.2 to
7.8).
5. Pour in 16 oz of Cal Spas "Metal Protector" to
center of spa.
6. Add either Bromine or Chlorine (According to your
preferred plan)
Bromine: Add 2 oz of Cal Spas "Go Brom" to
establish a bromine base.
Add 2 Cal Spas "Bromine Tablets" to
Bromine Floater.
Set floater opening at #2.
Chlorine: Add two tablespoons of Cal Spas
"Chlorine Granules" to the spa water.
7. Sprinkle 2 oz of Cal Spas "Oxidizer Shock" in the
center of the spa and turn on jets for 15 minutes.
Leave spa uncovered during this time.
8. Put cover on spa and allow to heat up to desired
temperature.
2007 Portable Spa Owner's Manual
LTR20071001, Rev. B
Water Quality Maintenance

Bromine Clear Water Plan

This plan and its chemical dosages are intended for
Cal Spas chemicals only. Most chemical manufacturers
use different chemical formulas and strengths. Only
Cal spas chemicals are specially formulated to provide
chemical balance at lower dosages. Always read and
follow printed instructions on chemical bottles and
packages.
Day One (Monday)
1. Test spa water using "Bromine Test Strips".
2. Based on the Test Strip readings:
• Adjust total alkalinity first (acceptable range of
80-120 ppm)
• Then adjust the pH if needed (range is
between 7.2 to 7.8).
• Add "Bromine Tablet(s)" if needed. (Do not add
more than 2)
• The recommended level of bromine is 3-5 ppm.
3. Add 2 oz of "Stain and Scale Defense".
4. Remove dirty filter from the spa and rinse off. Allow
to dry.
5. Place your extra clean filter cartridge back into the
spa.
6. Vacuum debris from the bottom of your spa with
the "Spa Vacuum".
Day Two (Wednesday)
1. Test spa water using Bromine Test Strips.
2. Based on the Test Strip reading: Adjust total
alkalinity, then the pH if needed.
Day Three (Friday)
1. Test spa water using Bromine Test Strips.
2. Based on the Test Strip reading:
• Adjust total alkalinity, then the pH if needed.
• Add one Bromine Tablet (if needed).
3. Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
minutes with cover off.
4. Replace cover.
Page 23