Cal Inline Sanitation System Clear Water Plan - Cal Spas Aqua SQ63 Manual Del Usaurio

Water Quality Maintenance

Cal Inline Sanitation System Clear Water Plan

This plan and its chemical dosages are
intended for spas equipped with the
optional Cal Inline Sanitation System.
The chemical references are designed
for Cal Spas chemicals only. Note:
Following these instructions is very
important to ensure proper operation of
your Cal Inline Sanitation System.
Start Up -- First Day
1. Clean surface of spa with Cal Spas
"Multi-Purpose Cleaner".
2. Apply a protective coat of Cal Spas
"Fast Sheen" to the acrylic surface.
3. Fill spa to proper water level with
normal tap water (Do not use soft
water)
4. Use Bromine Test Strip and balance
the spa water:
a. First, adjust total alkalinity
(acceptable range is 80-
120ppm),
b. Then adjust pH if necessary
(between 7.2 to 7.8).
c. Pour in 16 oz of Cal Spas "Metal Protector" to
center of spa.
d. Sprinkle 1 oz of Cal Spas Chlorinating
Granules over surface of water.
e. Power up spa and allow it to heat to desired
temperature.
Start Up--Next Day
Now that the spa has reached its normal operating
temperature, it is time to add the pre-filled mineral
cartridge and bromine cartridge.
1. Turn the power off to the spa.
2. Take a new Cal Spas "Mineral Cartridge" and open
to #6. (Hold the top of the cartridge and turn the
bottom counter clockwise)
3. Take a new Cal Spas "Bromine Cartridge" and
open to #3 (if the spa is less than 400 gallons,
open to #2) Note: These settings are start up
settings only. They may need to be adjusted up or
down depending on your spa usage.
Page 28
4. Unscrew the Cal Inline Sanitation System Cap
located on the top lip of the spa.
5. Grasp the handle of the cartridge holder and turn
counter-clockwise then pull up.
6. Remove the cartridge holder and discard spent
cartridges (if any).
7. Snap the Bromine Cartridge into the bottom portion
of the holder and the Mineral Cartridge into the top
portion of the holder. (Make sure the cartridges go
into the correct position as over-bromination will
occur if they are switched).
8. Line up the arrow on the top of the cartridge holder
with the arrow on the top of the system.
9. Lower the holder containing the cartridges down
into the system until the tabs on the holder line up
with the tabs on the system. Rotate the cartridge
holder clockwise until it stops. (To ensure a locked
position, attempt to pull the holder up. If it stays in
place, the lock is secure)
10. Screw cap back on. Do not over-tighten.
11. Power spa back up and set to desired temperature.
2007 Portable Spa Owner's Manual
LTR20071001, Rev. B