Receiving Fm Radio; Selecting A Station - Silvercrest SIRD 14 C3 Manual De Instrucciones

SilverCrest SIRD 14 C3
[DRC] This allows you to reduce the dynamic range between low and high-volume sounds. The
following options are available:

DRC high

DRC low

DRC off
Rotate the NAVIGATE knob [3] to select and press the NAVIGATE knob [3] to confirm. The
selected setting is marked with a
[Station order] You can sort the station list using the following options:

Alphanumeric (sort from A to Z)

Ensemble (sort by ensemble channel number)

Valid (sort from high to low signal strength)
Rotate the NAVIGATE knob [3] to select and press the NAVIGATE knob [3] to confirm. The
selected setting is marked with a

Receiving FM Radio

Use this operating mode to listen to FM radio stations.

Selecting a station

Proceed as follows to select a station:

Extract the telescopic antenna [11] fully.

Rotate the NAVIGATE knob [3] to tune to the frequency you want manually. To search for a
station automatically, press the NAVIGATE knob [3]. You can stop the station search by
pressing the NAVIGATE knob [3] again. Alternatively you can start or stop the station scan by
pressing the "OK (SCAN)" button [24].The display [1] indicates the current frequency in MHz.
As soon as a station has detected, the display [1] shows its name instead of the frequency. If
required, move the telescopic antenna into a different position or move the device to optimise
reception of the current station.
Depending on the direction of rotation of the NAVIGATE knob [3] the station search
starts increasing or decreasing the frequency.
92 - English
.
.