Motorola DTR Serie Manual De Instrucciones página 9

Charging Procedure
1. Plug the charger end of the power supply cord into the power
receptacle located at the bottom of the charger.
2. Plug the wall receptacle end of the power supply cord into
appropriate AC outlet. A successful power-up sequence in
indicated by a SINGLE FLASH GREEN on the charger indicator.
3. To charge a radio with battery (radio must be turned off):
a. Slide the radio into the charger pocket and align it to the groove
on each side of the radio with the corresponding raised rail on
each side of the charger pocket.
b. Ensure complete contact between the charger and radio
contacts.
4. To charge a stand-alone battery, insert the battery into the charger
pocket by:
a. Aligning the raised tab on each side of the battery with the
corresponding groove on each side of the charger pocket.
b. Pressing the battery towards the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete
contact between the charger and battery contacts.
5. When the radio or stand-alone battery is properly inserted into the
charger pocket, the charger indicates the Battery Level status as
shown in Table 6. The charger indicator illuminates in STEADY
RED to indicate the radio or stand-alone battery is charging rapidly.
When the battery is nearly or fully charged, charger indicator
changes to STEADY GREEN.
6. To remove a radio or stand-alone battery from the charger, use
both hands to remove a radio or battery from the charger pocket.
One hand to hold and support the charger while the other hand
removes the radio or battery.
7