At The End Of The Work; Maintenance; Recommended Maintenance Operations; Control And Cleaning Of The Brush - bluematic SD 43 ORBITAL Manual De Uso Y Mantenimiento

At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Disconnect the plug (1) of the power supply cable (2) in the mains
supply socket (3) (Fig.1).
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
ATTENTION: During this operation, do not rest your foot on
the appliance.
3. Tip the appliance back and take it to the maintenance
area and carry out all the procedures listed in the section
"RECOMMENDED PERIODIC
column "AT THE END OF THE WORK".
TYPE OF MAINTENANCE
Checking and cleaning the pad holder/brush
Checking and cleaning the solution tank

AT THE END OF THE WORK

3
1
2
2
MAINTENANCE" indicated in the

MAINTENANCE

RECOMMENDED MAINTENANCE OPERATIONS

ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
2. Turn the handlebar to the vertical position, press the uncoupling
lever (4) (Fig.2) and turn the handlebar to the vertical position
(Fig.3). When the handlebar is vertical, release the uncoupling
lever (4).
4
3
4. Once the maintenance work is finished take the appliance to the
designated machine storage place.
ATTENTION: Park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact with it.
X
X
29
X X
X X