Troubleshooting; Ec Declaration Of Conformity - bluematic SD 43 ORBITAL Manual De Uso Y Mantenimiento

This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the
information given here, please contact your nearest assistance centre.
PROBLEM
THE APPLIANCE DOES NOT SWITCH ON
INSUFFICIENT DETERGENT SOLUTION
ON THE PAD HOLDER
comply with the requirements of the following Directives:
• 2006/42/EC: Machinery Directive.
• 2014/35/EU: Low Voltage Directive.
• 2014/30/EU: Electromagnetic Compatibility Directive.
• 2011/65/EU: RoHS
The person authorised to compile the technical fi le:
Mr. Giancarlo Ruff o
Via Cà Nova Zampieri 5
37057 San Giovanni Lupatoto (VR) Italy
San Giovanni Lupatoto (VR) Italy, 20/06/2018

TROUBLESHOOTING

POSSIBLE CAUSE
The power cable extension is not connected
to the mains socket.
The power cable extension is not connected
to the appliance's power cable.
The electrical specifi cations of the appliance
should correspond to
specifi cations of the power supply network.
Extension cable damaged.
Overheating of the brush head motor.
The amount of detergent in the solution tank
is insuffi cient for the work that needs doing.

EC DECLARATION OF CONFORMITY

The undersigned manufacturer:
TMB S.r.l.
Via Cà Nova Zampieri 5
37057 San Giovanni Lupatoto (VR) Italy
declares under its sole responsibility that the products
Single brush machine mod. Bluematic SD 43 Orbital
32
Check that the plug on the extension cable
has been inserted into the mains supply
socket.
Check that the plug on the cable of the
appliance has been inserted into the socket
on the extension cable.
Make sure that the electrical specifi cations
of the appliance correspond to the electrical
the electrical specifi cations of the power supply network,
check the technical information on the serial
number plate.
Check the extension cable is not damaged,
and if it is, replace it.
Make sure that the thermal breaker on the
back of the handlebar has not tripped. If it
has, wait a few minutes until it has cooled
down, then press the specifi c circuit breaker
button to reactivate the power supply and
motor operation
Make sure that the amount of detergent
solution in the solution tank is suffi cient for
the work to be carried out, and if necessary
fi ll the solution tank.
SOLUTION
TMB S.r.l. TMB S.r.l.
Legal representative Legal representative
Giancarlo Ruff o Giancarlo Ruff o