Cutting With Trimmer Head - Maruyama B42L Manual Del Propietário

5. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
6. Stop the Trimmer / Brushcutter engine when mov-
ing between work sites.
CAUTION
• Always wear gloves and protective cloth-
ing when operating the Trimmer /
Brushcutter.
• If the Cutting attachment blade becomes jammed,
stop the engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a Trimmer / Brushcutter that has
chipped, cracked or broken cutting attachment or
shield.
[B42, B42A]
IMPORTANT: To detach the harness quickly
from the Trimmer / Brushcutter, push the red
button.
Red Button
[B42L]
IMPORTANT: To detach the strap quickly from
the Brushcutter, pull upward on the red band.
Ring

Cutting with Trimmer Head

• The tip of the line does the cutting. The line
should stay extended while cutting.
Three inches
(7.6 cm) above
ground
• Do not force the line into the material. Forcing
the line will cause it to slap against the material,
increasing line usage and causing poor cutting
results.
Trimming
Hold the bottom of the trimmer head about 3 in. (7.6
cm) above the ground and at an angle. Allow only the
tip of the line to make contact.
— US-21 —
Red Band
Strap
CORRECT
INCORRECT