Setting The Temperature; Using The Emergency Switch (Where Fitted) - Dometic GROUP WAECO CoolFreeze CFX35 Instrucciones De Uso

Operation
I
NOTE
Displayed temperature
 CFX 35, CFX 40, CFX 50, CFX 65:
The temperature displayed is that of the large interior com-
partment (fig. 7 1, page 5).
 CFX 65DZ:
With fridge/freezer divider in: The temperature displayed is
that of the freezer compartment (fig. 8 1, page 5).
✓ The cooler starts cooling the interior.
I
NOTE
When operating with the battery, the display switches off auto-
matically if the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2 1, page 3) down, until it latches in
place audibly.
6.6

Setting the temperature

➤ Press the "SET" button (fig. 3 4, page 3) once.
➤ Use the "UP +" (fig. 3 7, page 3) and "DOWN -" (fig. 3 6,
page 3) buttons to select the cooling temperature.
✓ The cooling temperature appears in the display for a few
seconds. The display flashes several times and then the current
temperature is displayed again.
6.7

Using the emergency switch (where fitted)

The emergency switch (fig. 5 1, page 4) is located below the con-
trol panel. For normal operation the switch is in the "NORMAL USE"
position.
➤ If an electronic control failure occurs, slide the switch to
"EMERGENCY OVERRIDE" position
I
NOTE
If the switch is in the "EMERGENCY OVERRIDE" position, the
cooler freezes with full cooling capacity.
38
CFX35 – CFX65DZ
EN