Symbols On The Product - Husqvarna 525DEPS Manual Del Usuario

19. Chain oil tank
20. Operator's manual
21. Transport guard, bar
22. Hex key
23. Combination wrench
24. Combination wrench, chain tensioner
25. Harness
26. Spark plug cap and spark plug
27. Shaft coupling
28. Impact guard
29. Dielectric chain oil
30. Two-stroke engine oil

Symbols on the product

Warning! This product is dangerous. Injury
or death can occur to the operator or
bystanders if the product is not used
carefully and correctly. To prevent injury to
the operator or bystanders, read and obey
all safety instructions in the operator's
manual.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves during
operation and maintenance. Use protective
boots or shoes with non-slip soles. Use
clothing of strong fabric and of full length.
Fuel.
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
1480 - 003 - 05.08.2020
If the product touches or comes close to high-voltage power lines it could lead to death or
serious injury. Electricity can jump from one point to another by arcing. The higher the volt-
age, the greater the distance electricity can jump. Electricity can also travel through branch-
es and other objects, especially if they are wet. Always keep a distance of at least 10 m be-
tween the machine and high-voltage power lines and/or any objects that are touching them.
If you have to work within this safe distance you should always contact the relevant power
company to make sure the power is switched off before you start work.
The operator of the product must ensure, while working, that no persons or animals come
closer than 15 meters.
Obey minimum approach distance according to OSHA 1910.269 and employer guidelines.
Chain oil.
Adjustment of the oil flow.
Primer bulb.
Choke.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
The rating plate shows the serial
number. yyyy is the production
yyyywwxxxxx
year, ww is the production week
and xxxxx is the sequential number.
The dielectric shaft section shows
the test date code. mm is the test
mm/dd/yy
month, dd is the test day and yy is
the test year.
Direction of rotation, saw
chain.
3