Using The Appliance - BOMANN BS 9019 CB N Manual De Instrucciones

Electrical Connection
• Before connecting the plug to the wall socket, check wheth-
er the mains voltage is correct. Refer to the information on
the rating plate of the device.
• Connect the appliance to a certified wall socket only.

Using the Appliance

1. Insert the mains plug into a correctly installed power socket.
2. Turn the appliance on by the on/off switch by pressing
down the button.
3. Set the "carpet/hard floor" switch, depending on the floor
covering.
4. Vacuum at a steady speed. There is no need to exert pres-
sure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
Air Slide
Open the air slide on the hose handle in order
to regulate the airflow or to clear any particles
sticking to the nozzle.
Switching Off and Winding Up the Mains Lead
1. Turn the vacuum cleaner off by the on/off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
Maintenance
Dust Bag Replacement Display (10)
Hold the hose up into air. If the display for the vacuum bag
change shows "red", the dust bag is full. Please change it.
Changing the Dust Bag
1. Pull the plug out of the socket.
WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
2. Use the opener (13) to open the lid of the dust bag com-
partment.
NOTE:
The lid can be locked in upright position. Do not push the
lid beyond the locking mechanism! Otherwise the mount-
ing could break away.
3. Lift up and remove the dust bag holder. Remove the dust
bag by taking it from the holder.
4. Insert a new bag. Please ensure that the bag is located
correctly in the guide mechanism.
5. Insert the dust bag with the holder into the designated
slot. The bag must be located completely in the dust bag
compartment. Close the cover so that it snaps into place.
Filter
Your appliance has two filters.
Motor Protection Filter (Inlet Filter)
The inlet filter is located in the dust bag compartment. The
filter is located vertically in the rear section of the dust housing.
Remove the filter by pulling upwards.
Cleaning the Filter Element
Clean the engine protection filter after 10 dust bag changes. If
necessary, the filter can also be washed in warm water without
any additives. Place it back into place only once it is completely
dry!
Outlet Filter (6)
The appliance is also equipped with an outlet filter.
It is located on the back of the device behind the cover.
1. Push the lever towards the left and remove the ventilation
grid.
2. Remove the filter insert and clean it as described above.
3. Once dried completely, reinstall the filter insert.
4. Refit the ventilation grid in the device. Pay attention to
the guide tabs. The ventilation grid must audibly click into
place.
Cleaning
31