The unit, accessories and packaging should be sorted for environment-friendly recycling.
Description
Dremel Versatip
Model number
2000
Power source
Refined butane gas
Tank capacity
± 17 ml. / ± 9 grams
Run time
± 45 minutes (highest setting)
± 90 minutes (lowest setting)
Heat-up time
Instantly (open flame)
± 25 seconds (tips)
Nominal heat input
12 g/h
(consumption)
Cool-down time
Flame guard: 15 min. (< 25°C)
Tips: 17 min. (< 25°C)
Temperature
1200°C (open flame)
680°C (hot air)
550°C (tips)
Weight
135 grams (empty tool)
Please familiarize yourself with the components of the Dremel Versatip (figure 1), the different tips (figure 6) and the kit content
(figure 7) before use.
DREMEL VERSATIP
1. Catalyst
2. Flame guard
3. Flame guard nut
4. Ceramic insulator
5. Child Safety Lock (stopper)
6. Trigger
7. Lock (for continuous working)
8. Flame control knob
9. Tank
10. Filling valve
KIT CONTENT
1. Tool with cap
2. Pocket to store cap
3. Shaping knife
4. Wide flame head
5. Deflector
6. Pocket for soldering tip
7. Additional empty pocket
8. Cutting knife
9. Hot air tip
10. Tin box with soldering sponge
11. Tin box for hot tips
GB
DISPOSAL
SPECIFICATIONS
USE
12. Soldering tin
13. Pocket for 2 wrenches
Remove the carton cover from the ignition switch before using
the Dremel Versatip.
The Dremel Versatip runs on liquid butane gas. Make sure the
gas you are using is refined butane gas that can also be used
in lighters.
Hold tool and container as shown in picture 8. Then fill the
tank with liquid butane gas observing the instructions on the
butane gas container. The tank is full when liquid butane gas
escapes through the filling valve.
WARNING
!
The Dremel Versatip is equipped with a child safety
mechanism. This mechanism requires two handed operation
to protect against (accidental) ignition by children.
1. See figures 2 and 3 to ignite the Dremel Versatip.
2. The ceramic insulator will start to glow shortly after
5
(RE)FILLING THE TANK
Do not overfill the tank!
GETTING STARTED