Preparing The Washer; Electrical Requirements - Mi-T-M Corporation cm series Manual De Operation

eleCTRICAl RequIRemeNTS

CAuTION: To avoid electrical shock, connect
the washer to a properly grounded electrical
receptacle. do not use an adapter or remove third
(ground) prong.
make certain the connection between the washer
power cord and receptacle is kept dry.
The following electrical requirements must be met:
1. The electrical supply must provide a minimum of 110 to
120 volts. With the washer operating, line voltage must
not drop below 108 volts.
ImPORTANT: Operating the pressure washer with
low line voltage may damage electrical
components and cause motor to stall.
2. This pressure washer is equipped with a Ground Fault
Circuit Interrupter in the power cord to reduce the risk
of electrical shock. However the GFCI will not protect
against all faults, short circuits, or overloads.
ImPORTANT: The gfCI muST be reset each time the
washer is unplugged and plugged in
again.
14

Preparing the Washer

Operator's Manual