Maintenance; Cleaning The Appliance; Troubleshooting - Imetec i1901 Instrucciones De Uso

EN
• Wait for the appliance to cool down completely before putting it away. The reservoir
does not have to be emptied.
NOTE: If the appliance is not to be used for several weeks, empty the water
reservoir completely; wait for the appliance to cool down completely and turn it
over to allow all the water to flow out of the reservoir. When it switches on, refill
the tank and follow the instructions in the "Filling the tank" chapter.

Cleaning the appliance:

Switch the appliance off and disconnect the plug (5) from the socket before cleaning.
When necessary, clean the appliance with a damp cloth. Do not use solvents or other
aggressive or abrasive detergents. Otherwise, the surface could be damaged.
Make sure all cleaned parts are completely dry before reusing the appliance.
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The appliance does not
go on.
The plate temperature LED
(13) goes on and off.
A little smoke comes out
of the appliance when it
is switched on for the first
time.
Impurities come out of the
plate of the new iron.
14

MAINTENANCE

TROUBLESHOOTING

Possible cause
The household appliance is not on.
Normal procedure.
This is absolutely normal and is
due to the expansion of the plastic
material.
This can occur in a new iron.
Solution
Verify that the appliance is connected
correctly to the power cord and the ON/OFF
button (4) is pressed.
The switching ON and OFF of the LED (13)
indicates the heating phase of the iron. The
LED goes off once the set temperature is
reached.
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used a
few times.