Sync Mode; The Sync Tab; Client Upload - Interacoustics AC40 Manual De Instrucciones

AC40 Instructions for Use - EN

3.9.2 SYNC Mode

One click data transfer (Hybrid Mode disabled)
If the "PC controlled instrument" setting in the General Setup (see above) is deselected, the current
audiogram will be transferred to the Diagnostic Suite as follows: When pressing Save Session on the
instrument, the session will automatically be transferred to the Diagnostic Suite Start the suite with device
connected

3.9.3 The Sync Tab

If there is several sessions stored on the AC40 (under one or more patients) then the Sync tab must be
used. The screen shot below shows the Diagnostic Suite with the SYNC tab open (underneath the AUD
and IMP tabs in the upper right corner).
The SYNC tab provides the following possibilities:
Client upload is used for uploading clients from the database (Noah or OtoAccess) to the AC40. The
internal AC40 memory can hold up to 1000 clients and 50.000 sessions (audiogram data).
Session download is used to download sessions (audiogram data) stored in the AC40 memory into to
Noah, OtoAccess or XML (when running Diagnostic suite without a database).

3.9.4 Client Upload

The following screen shot shows the client upload screen:
•
On the left side it's possible to search for the client in the database to transfer to the database
using different search criteria's. Use the "Add" button to transfer (upload) the client from the
database to the internal AC40 memory. The internal AC40 memory can hold up to 1000 clients
and 50.000 sessions (audiogram data)
•
On the right side the clients currently stored on the internal AC40 memory (hardware) is down.
It's possible to remove all clients for individual clients using the "Remove all" or "Remove"
buttons.
Page 42