Window Function; Temperature Offset - Cooper Hand Tools Weller WD 1 Manual De Uso

English
status is ended by pressing the UP or DOWN button.
In the case of soldering work with very low heat require-
ment, the reliability of the Setback function may be impaired.
Change the setback time with the UP or DOWN button.
Switch to previous menu item with I.
Switch to next menu item with II.
4.1.3 Temperature switch-off Off time
When the soldering tool is not in use, the heating system of
the soldering tool is switched off when the Off time has elap-
sed. The temperature can be set from 0 – 999 minutes. With
a setting of "0 min", the setback function is switched off.The
temperature switch-off is carried out independently of the
set setback function. The actual temperature is displayed
(flashing) and serves as a residual heat indication; "OFF"
appears in the display. Below 50°C (150°F), a flashing dash
appears.
Change the off time with the UP or DOWN button.
Switch to previous menu item with I.
Switch to next menu item with II.

4.1.4 Temperature offset

The actual soldering tip temperature can be changed by
±40°C/±72°F through the input of a temperature offset.
Change the offset value with the UP or DOWN button.
Switch to previous menu item with I.
Switch to next menu item with II.
37

4.1.5 Window function

Restriction of the temperature range to a max. ±99 °C
(±180 °F), beginning with a previously locked temperature
(see 4.1.7). The locked temperature thus represents the
middle of the settable temperature range.
Use the UP / DOWN buttons to change the window size.
Switch to previous menu item with I.
Switch to next menu item with II.
4.1.6 °F/°C Switch-over
Switching the temperature version from °C to °F and vice
versa.
Use the UP/DOWN buttons to switch between °C and °F.
Switch to previous menu item with I.
Switch to next menu item with II.
4.1.7 Interlock function "
Locking the soldering station. After locking, no more setting
changes at the soldering station are possible. Operation of
"