Stadler Form Emma Manual De Instrucciones página 6

• Do not run the power cord over sharp edges and make sure that it does
not get trapped.
• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
• Only use the adapter provided by the manufacturer.
Before setup
A. Take the travel bag (1) and the bag containing the adapter and cable (2)
out of the packaging. Open the travel bag (1) and take out the bottle (3).
B. Now turn the lid (4) to open the bottle and take the housing (5) out of the
bottle.
C. Fold out both of the supporting feet (6) to improve the stability of the
appliance when the bottle is full.
Setting up / operation
1. Place Emma in the desired location, on a flat surface. Connect the USB
cable (7) to the power adapter (8) and to the housing (9) and insert the
adapter into a suitable mains socket. Alternatively, you can also con-
nect the USB cable to another power source such as an external battery
pack/powerbank with at least 2A.
2. Fill the bottle (3) with clean, cold tap water and seal it by putting the lid
(4) on the bottle and turning it as far as it will go.
3. On the housing cover (10), there is a recess in which the bottle (3) is
placed. Place the bottle (3) in this recess with the lid (4) facing down-
wards. Water will now flow into the water tray (11). Important: every
time you take off and put back the bottle (3), some water will run into
the tray (11). If you do this too often, the water tray (11) may overflow
and damage the appliance. We therefore recommend that you only take
off the bottle when it needs to be refilled with water.
4. Switch on the appliance by pressing the On/Off button (12). After it has
been switched on, the LEDs (13) on the left next to the On/Off button (12)