Connecting Components - Beurer EM34 Manual De Instrucciones

Connecting Components

1. Snap the ends of the power wire
onto the power wire connectors on
the cuff. The two ends are inter-
changeable and do not have a
specific left or right.
2. Moisten the rubber electrode cov-
ers with water, as well as the area
on your body to be treated.
3. Place the cuff around your knee or
elbow, as desired. Ensure the rub-
ber electrode covers are properly
positioned over the desired treat-
ment area and the opening in the
cuff is over your knee/elbow.
4. Tighten and secure the hook and
loop straps.
5. Insert the power wire plug into the
power wire jack on the control unit.
1. Press the On/Off Button to switch the device on. The
device will beep three times and the logo will flash and
then illuminate.
2. Use the ▲/▼ buttons to select an intensity level from
1 - 25 that feels most comfortable. The "low" intensity
indicator will flash for levels 1-8, the "middle" intensity
indicator will flash for levels 9-17, and the "high" inten-
sity indicator will flash for levels 18-25. The higher the
level within each range, the faster the indicator will flash.
NOTE: When setting the level, the control unit will beep
once. If it beeps twice, there may not be enough water
on the rubber electrode covers to conduct enough cur-
rent, or the power wire is not attached properly.
3. This device will switch between two treatment modes by
itself. If you prefer one treatment mode over the other,
you can manually select it by pressing the On/Off Button
during treatment; the Indicator above the "M" will illumin-
ate briefly, indicating that the manual selection mode is
active. To return to auto mode, press the On/Off Button
again; the indicator above the "A" will illuminate briefly.
4. To shut the device off at any time, press and hold the
On/Off Button until the control unit emits one long beep
and the logo shuts off. It will also shut off by itself after
30 minutes of use.
5. Always remove the cuff directly after treatment.
9