Getting Started; Inserting/Replacing Batteries; Cuff Size; Setting The Date And Time - Beurer BC 30 Manual De Instrucciones

For product information, questions or customer service call
toll free 1-800-536-0366 or email: info@beurer.com

5. Getting started

WARNING:
• This product does not and is not intended to provide a
medical diagnosis. Measurements results are for refer-
ence only. Self-diagnosis and treatment, e.g. regarding
medication, using measured results represent a risk for
your health. Always consult with a licensed physician
for determination of appropriate medication and dos-
age thereof. Follow the instructions of your physician
or licensed healthcare provider. If you have or suspect
that you have a medical problem, promptly consult your
physician. If you have an emergency please call 911
immediately.
• Only a physician or a trained health care professional
who is familiar with your medical history is able to ac-
curately interpret your blood pressure measurements.
Consult your physician before starting blood pressure
monitoring.
NOTE:
To conserve the batteries, the monitor switches off auto-
matically if you do not press any buttons for two minutes.

5.1 Inserting/Replacing batteries

• Remove the battery compart-
ment cover on the left side of
the device.
• Insert or replace with only two
AAA 1.5 V alkaline batteries. Make absolutely sure that
you insert them with the correct polarity (+/-) as indicated
(see the diagram inside the battery compartment).
Do not use other types of batteries.
• Replace the battery cover carefully. If the battery change
icon is continuously illuminated, measurement is no
longer possible and you must replace all the batteries.

5.2 Cuff Size

WARNING:
• Proper cuff size is important for accurate measure-
ments. Only use the device on adults who have the
right wrist circumference for this instrument.

5.3 Setting the date and time

It is essential to set the date and time. Otherwise, you will
not be able to save your measured values correctly with a
date and time and to access them again later.
To set the date and time, proceed as follows:
1. After inserting the batteries:
12