Abus TVIP10005B Manual De Instrucciones página 25

Accept the settings by pressing "SAVE" or cancel them by pressing "Cancel". If
the network configuration is changed, then the camera must be restarted (System
\ Initialize \ Restart).
Wireless (TVIP10055B only)
The camera features a WLAN network interface for wireless data transmission in an IP network. The network
camera must be connected via a network cable for the initial configuration of all WLAN parameters.
WLAN:
MAC address:
IP address:
WLAN status display:
ESSID:
Signal strength:
Security:
Wireless mode:
Connect:
Disconnect:
Manual:
Update:
ESSID:
Manual setting:
Mode:
Infrastructure
Ad-Hoc
Authentication:
Open
Common key
WPA-PSK/WPA2-PSK
Encryption:
Enable or disable the WLAN interface.
Shows the MAC address of the wireless interface.
The set IP address is displayed here. The address can be assigned
automatically (DHCP) or manually (see below).
The camera automatically searches the environment for WLAN access points
(APs).
Shows the name of the wireless network. If a connection to an access point
has been established, this is indicated by the character "v" before the ESSID
name.
Shows the signal quality in percent. To ensure a good connection, this value
should not be below 60%.
Indicates the way in which the network is protected (encryption type).
Shows the WLAN standard that the access point (AP) supports.
When this button is pressed, the software attempts to connect to the selected
access point. Additional data important for the connection must be configured
in another window (it may be necessary to disable the pop-up blocker). The
IP address is automatically determined.
The connection to the selected access point is disconnected.
Manual configuration of all data required for a wireless connection.
When this button is pressed, the list of available access points is updated.
The ESSID is the name of the access point.
Manual setting of the ESSID.
Select the WLAN connection mode here.
The network camera is connected to the network via an access point.
In this mode, the network camera can communicate directly with another
network adapter (network card). What is known as a peer-to-peer
environment is set up.
Here you can set the encryption mode for the wireless transmission.
No encryption selected.
(WEP, Wired Equivalent Privacy) A 64- or 128-bit key is used for encryption
(HEX or ASCII). For communication with other equipment, these keys must
be the same on both devices.
(10/26 HEX characters or 5/13 ASCII characters according to bit length)
(Wi-Fi Protected Access – Pre-Shared Keys) With this method, dynamic keys
are used. TKIP (Temporal Key Integrity Protocol) or AES (Advanced
Encryption Standard) can be selected as the encryption protocols. What is
known as a passphrase (pre-shared key) must be assigned as the key.
(64 HEX characters or 8 to 63 ASCII characters)
Select the corresponding type of encryption here.
Common key: WEP / disabled
WPA-PSK / WPA2-PSK: TKIP or AES
25