Turning The Rear Handle (11); Starting The Hedge Trimmer (09); Eco Mode / Power Mode (10); Working Behaviour And Working Tech- Nique (12) - AL-KO SOLO HT 4260 Manual De Instrucciones

GB
and turn slightly clockwise until the locking
and unlocking switch (08/3) audibly engages.
Dismounting the connecting cable
1. Pull the locking and unlocking switch (07/3)
backwards (07/b), turn the connector slightly
to the left and pull out (07/c).
2. Pull the locking and unlocking switch (08/3)
backwards (08/b), turn the connector slightly
to the left and pull out (08/c) of the connec-
tion socket of the appliance (08/2).
5.4

Turning the rear handle (11)

Turning the handle
1. Press the unlock button (11/1).
2. Turn the handle to the left or right by 90 ° (11/
a) until it engages.
3. Release the unlock button (11/1).
Turning the handle back
1. Press the unlock button (11/1).
2. Turn the handle back to the initial position un-
til it engages.
3. Release the unlock button (11/1).
5.5

Starting the hedge trimmer (09)

1. Stand securely.
2. Hold the front handle (09/1) with one hand
and the rear handle (09/2) with the other
hand.
3. Press the safety switch on the front handle
(09/a), then press the on/ off switch on the
rear handle (09/b). The appliance starts.
4. Keep both buttons pressed while working.
When a button is released, the appliance
switches off.
5.6

Eco Mode / Power Mode (10)

The appliance is equipped with an Eco Mode/
Power Mode mode. Select between the Eco
Mode (approx. 1200 min
-1
(approx. 1500 min ) by pressing the button
(10/1).
If the Power Mode is switched on, the green LED
display lights.
If the appliance is switched off and then switched
on again, it starts with the previously selected
setting.
30
-1
) and the Power Mode
Working behaviour and working technique (12)
6 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (12)
WARNING!
Increased risk of falling
There is a greater risk of falling if work is
carried out from an elevated position
(e.g. ladder).
■
always work with the appliance from
the ground and make sure that you
are standing securely.
■
Heed the safety instructions.
■
Cut the hedge regularly and only at the per-
mitted times.
■
Only cut off the thin branches and new
growth on the surface of the hedge; do not
cut too deep.
■
Always cut the two sides of a hedge first, fol-
lowed by the top. This prevents cut material
from falling into areas that you have not yet
trimmed.
■
Hedges should always be trimmed into a
trapezoidal shape (tapering toward the top).
This prevents the leaves on the lower
branches from being shaded out (12).
■
Make sure the motor is stopped before you
remove any cuttings.
■
When leaving/transporting the appliance:
■
Switch off the appliance.
■
Fit the protective cover.
■
Remove the battery.
■
After use, remove the battery and check the
appliance for damage.

7 MAINTENANCE AND CARE

WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into sharp-edged, moving appliance
parts and into cutting tools.
■
Before maintenance, care and
cleaning work, always switch off the
appliance. Remove the recharge-
able battery.
■
Always wear protective gloves
during maintenance, care and clean-
ing work.
HT 4260 | HT 4245