Spraying; Storage And Maintenance - Jacto HH-5 Manual Del Operador

3. Fill with the plant protection product. Do not remove the
cone lid for filling. It iprevents against spillage of chem-
icals;
4. Install the cylinder again and rotate clockwise to lock it;
5. Unlock the handle and pump at least 30 times or until the
pressure relief valve opens;
6. Lower the handle and turn it clockwise to lock it;
7. The sprayer is ready for use and can be transported verti-
4/21
cally on the shoulder by the strap;
8. After spraying, remove the internal pressure by lifting up
on the pressure relief valve according to the operation 1.

3.5. Spraying

The blue adjustable cone nozzle that comes along with this
compression sprayer can be adjustable to apply as a spray or a
jet. As shows below:

4. Storage and Maintenance

1. The sprayer must not be stored with any chemical inside
and / or stored with internal pressure.
2. After the application, remove all internal pressure, empty
the tank, clean and wash all equipment in a place where
there is no risk of contamination.
3. Periodically lubricate the sprayer by removing the handle
from the cylinder and lubricating the piston ring as indi-
cates in the figure below: