Disposal Note - LRP ANTIX LiPo - 2S - 7.6V Manual De Usuario

USER MANUAL
ANTIX
BY LRP
cial attention that the LiPo-battery does not get damaged or warped by letting it fall
down, hitting it, bending it or by similar actions.
• Never charge several LiPo-battery packs at once with one charger. The different
capacities and charge levels can lead to serious overcharging of the battery, even if
you are using a charger with LiPo capabilities.
• Damaged packs cannot be used any longer. If the packs show signs of damage, are
bent or similar, do not use the packs anymore.
• The chemical reaction during charging and discharging a LiPo-battery is not fully
reversible. Due to that, LiPo-batteries loose capacity during their life-span. This is
normal and neither a manufacturing nor production fault.
DISPOSAL NOTE: Damaged packs or packs, which can no longer be used are haza-
rdous waste and have to be disposed of accordingly.
6. STORAGE !!!
For a storage over a longer period of time, we recommend to charge the battery up
to 50% of the nominal capacity. Therefore fully discharge the battery pack and then
partially charge it with a charge current of 1C for 30 minutes or charge it up to a voltage
of 3.85-3.90V/cell. In this condition, the battery can be stored at least 3 months at 25°C
room temperature without the need of recharging it. If the batteries are stored longer,
be sure to make a complete charge and discharge cycle every 3 months and partial
charge it again for storage. We also recommend this procedure before the first use in a
model after the battery has been stored for 2-3 months or longer.
ATTENTION: NEVER STORE THE BATTERY COMPLETELY EMPTY OR FULLY CHAR-
GED. Both will harm the battery and lead to swollen battery cells. A fully charged
battery will have the same negative effects as a completely discharged battery.
Even if you are using your battery regularly every week, always pay attention that the
battery is partially charged with at least 30% of the nominal capacity during storage.
A partial charge with 1C charge current for 20 minutes is sufficient in this case, if the
battery was competely empty before.
7. INTERESTING FACTS ABOUT LIPO BATTERIES
• LiPo batteries shall only be charged at a temperature between 0-45°C. If this will not
be observed, the cycle life of the battery will be reduced drastically.
• The single cell open circuit voltage of a fully charged LiPo battery is 4.2V (4.35V HV).
The single cell open circuit voltage of a 50% partial charged LiPo battery is approx.
3.85V (3.90V HV). The single cell open circuit voltage of an empty LiPo battery is
approx. 3.3V.
• A voltage below 3.3V per cell without load is in either case harmful for a LiPo battery.
Therefore always avoid voltages below 3.3V per cell.
• It is not visible from the outside when a LiPo battery gets overcharged. The only
way to find this out is to measure the voltage of the LiPo battery. The battery does
not heat up nor does it swell when it gets overcharged. Therefore always check the
battery voltage during charging. If it exceeds the max. charging voltage stop the
charging process immediately and check all settings.
• We recommend to stop discharging a Lipo battery if the remaining capacity reaches
30% of the nominal capacity. With this, LiPo batteries will have the max. possible cy-
cle life. Real-Life application showed, that the cycle life of LiPo batteries is reduced if
the battery always gets completely discharged. This phenomenon can be seen with
all types of LiPo batteries.
Repair procedures / limited warranty
All products from ANTIX by LRP are manufactured according to the highest quality
standards. ANTIX by LRP guarantees this product to be free from defects in materials
or workmanship for 90 days (non-european countris only) from the original date of
purchase verified by sales receipt. This limited warranty doesn´t cover defects, which
are a result of misuse, improper maintenance, outside interference or mechanical da-
mage. This especially applies on already used batteries or batteries, which show signs
of heavy usage. Damages or output losses due to improper handling and/or overload
are not a product fault. Signs of wear (loss of capacity) after intensive usage are also no
product fault. The following points do also result in a service fee:
• Original power plugs replaced with a NON reverse polarity protected power plug
system (Stickpacks).
• Use of a non reverse polarity protected power plug system (Competition batteries).
• Send in the battery without power plugs.
• Removed or damaged original heatshrink.
To eliminate all other possibilities or improper handling, first check all other compo-
nents in your model and the trouble shooting guide, if available, before you send in
this product for repair. If products are sent in for repair, which do operate perfectly, we
AA00672 © LRP electronic GmbH 2017
HV-LIPO PACKS
Battery disposal notes: Batteries and accumulators used in this product are to be disposed of separately from your household waste. Batteries and accumu-
lators must not be disposed of as unsorted municipal waste. Users of batteries and accumulators must use the available collection framework for the return,
recycling and treatment of batteries and accumulators. Customer participation in the collection and recycling of batteries and accumulators is important to
minimise any potential effects of batteries and accumulators on the environment and human health due to substances used in batteries and accumulators.
have to charge a service fee according to our pricelist.
With sending in this product, the customer has to advise ANTIX by LRP if the product
should be repaired in either case. If there is neither a warranty nor guarantee claim, the
inspection of the product and the repairs, if necessary, in either case will be charged
with a fee at the customers expense according to our price list. A proof of purchase in-
cluding date of purchase needs to be included. Otherwise, no warranty can be granted.
For quick repair- and return service, add your address and detailed description of the
malfunction.
If ANTIX by LRP no longer manufactures a returned defective product and we are un-
able to service it, we shall provide you with a product that has at least the same value
from one of the successor series.
The specifications like weight, size and others should be seen as guide values. Due to
ongoing technical improvements, which are done in the interest of the product, ANTIX
by LRP does not take any responsibility for the accuracy of these specs.
ANTIX by LRP-Distributor-Service: - check www.ANTIX-by-LRP .com
LRP electronic GmbH
Hanfwiesenstraße 15
73614 Schorndorf
Deutschland
ENGLISH