Description; Safety Instructions; General Power Tool Safety Warnings; Before Use - Hilti PSA 100 Manual De Instrucciones

2 Description

2.1 Use
The monitor is designed to be used to display, and thus
allow evaluation, of scans made with Hilti scan systems.

3 Safety instructions

3.1 General power tool safety warnings

Read the operating instructions stored in memory in the
tool.
a) Keep children away. Keep other persons away
from the working area.
b) Check the display after switching the tool on. The
display should show the Hilti logo and the name of the
tool. The disclaimer notice subsequently displayed

4 Before use

4.1 Inserting the battery pack and switching the tool on 2 3
1. Insert the PSA 82 battery pack in the back of the tool.
2. Fully charge the PSA 82 battery pack (please refer to the operating instructions for the PUA 81 mains adapter,
the PSA 82 battery pack and the PUA 82 charger for use in motor vehicles).
NOTE Alternatively, the PSA 82 battery pack can be removed from the PSA 100 monitor and charged using the
separately available PSA 85 charger.
3. Switch the tool on by pressing the on/off button.
4. You must accept the terms of the disclaimer notice displayed on the screen before the tool can be operated.
5. To switch off, press and hold the on/off button for 3 seconds.
4.2 Settings
When operating a brand new tool you will first be requested to select the country-specific settings.
1. Use the 4-way controller to select the desired language and confirm your choice by pressing the "OK" button.
2. Make further settings using the 4-way controller and the "OK" button.
3. Use the "OK" button to confirm the settings made.
NOTE You can also use the "Skip" button to skip making these settings until the next time the tool is switched
on.
Scans can be managed in projects and subsequently
transferred to a PC for data evaluation and archival.
must be accepted by the user before the main menu
for the current project can be accessed.
c) The warnings shown in the display must always
be observed.
d) Make sure that the display area can be easily
read (e.g. do not touch the display area with the
fingers, keep the display area clean).
e) Do not use the tool if it is defective.
f) Always check how the tool is set before using it.
g) Always remove the battery pack before transport-
ing the tool.
h) Store and transport the tool safely. The storage
temperature must be between -25°C and 63°C.
i) When the tool is brought into a warm environment
from very cold conditions, or vice-versa, allow it
to become acclimatized before use.
en
7